Its Working Again :)

So I pulled everything off the shelf to give this a test. Its working. What I have done in the pictures below was to use an DDS vfo as the incoming 7mhz signal. It run into as much attentuator as I have here, giving a final signal out of about -95dbm or there abouts according to the spec-an. This number is rather uncertain because that is right on the noise floor of the device and by my calculations, the actual signal is closer to -100dbm. Now I am still hearing a signal out of the speaker at that level. So its not an Icom, but its not totally deaf either. I do think i could use a little more gain in the audio stages. But, we will see how things pan out with some loudish signals on 40m this afternoon.

The receiver setup with the attenuators.
DDS VFO used as the signal source.
Function Generator being used as the VFO and BFO.

 

Facebooktwitterredditpinterestlinkedin