100w Amp Repairs

So when i initially powered this up it was transmitting into a dead short. Obvious not a good thing, but on a good note, one bank of fets actually survived because I did not turn the bias way up on it by mistake LOL.

Anyway, this was way easier to pull apart than I was expecting it to be. Now i just need to run down the shops and get some solder wick to clean up the pads and drop in 4 new fets and then power it back up again. You will notice now there is a wire bridging the pads where the output relay is. Yeah this time it will be dumping rf into a dummy load. LOL

Facebooktwitterredditpinterestlinkedin