Clickety Clack of the Relays

Slowly integrating all these bits together in software and currently all the relays are clicking in sequence when I change bands on the control board. If you look closely on the upper right, you will see an updated version of the Band Pass Filter board that uses different inductors and filter topology. I need to populate and test one filter to ensure its right and then build the entire board.

Something that I did not notice was that when I changed Ecad software my mounting hole pattern has changed slightly, so neither of the old filter board designs will stack with the other boards. So i have to redo the low pass filter board and I am going to redo the rf frond end board as well and move things around to make it a little more usable and to make sure the 3.3v regulator has a heatsink on it. With bugger all current running though it, it still gets burn your finger hot and that is not right. I am starting to wonder if these ebay parts are actually dodgy or something.

Facebooktwittergoogle_plusredditpinterestlinkedin